Ask Your Long Island Heating Experts about a Boiler Installation

Step-by-step wall hung boiler installation

Ever wonder what exactly would happen if you called a Rebmann professional to come out and install a wall hung boiler in your home? Well, we can relieve you of that curiosity right here, right now because we have a step-by-step account of an installation performed recently by one of our technicians.

1. Remove the existing furnace coil and air handler
2. Install a new high efficiency wall hung combination hot water and heat Navien CH230 direct vent boiler
3. Install new secondary heat supply piping
4. Install new intake and exhaust on outside of house
5. Install new ADP air handler with DX cooling and heating up to 120 MBH
6. Install new galvanized metal base box
7. Install new supply and return transitions
8. Connect existing R-22 condenser to new air handler
9. Wire all low voltage
10. Install new line voltage circuit for new boiler
11. Install two new floor registers and new insulated duct in garage
12. Obtain electrical permit inspection for new line voltage
13. Use existing line voltage for new air handler
14. Install new Honeywell wireless thermostat and equipment
15. Interface module to consolidate thermostats
16. Install new gas line from meter point of entry into the garage to the new boiler
17. Install new April Air 600M Humidifier with ball shut-off valve
18. Balance and charge the system

We want you to know exactly what to expect when we arrive at your home for a boiler installation – no surprises. Call Rebmann Plumbing today for all of your boiler installation, repair, and service needs.